1Z 021BF - Clutch sensor swich in codeblock 1 (automatic)

by **djexit** » Thu May 29, 2014 10:50 am

Hi, I want to use two maps banks (codeblock) in MSA15 ECU with numbers 028 906 021 BF for original and modified maps. Originally codeblock 1 is for automatic transmission and codeblock 2 for manual gearbox. I want to make originally codeblock 1 for original maps (with manual gearbox), so I am looking for adress where i can switch ECU to use clutch sensor like in original codeblock 2.

There is original firmware:
http://www.chip-tuner.hu/original_ecu_f ... 67-868.zip

by **djwacik** » Thu May 29, 2014 4:34 pm

Just compare data for both blocks and you will find all the differencies...

by **djexit** » Fri May 30, 2014 9:34 am

Ok, I know, but comparing two codeblock in hex editor is simply difficult, when i don't know which address is responsible for clutch sensor. I have the DAMOS file for MSA15 but address descriptions are in hard to translate stricte technically and full of shortcuts German.. :/ I search this file for word "Kupplung" (it is means "Chlutch" in German) and i found two address with this word in description:

$024D0 Wartezeit bis Kupplung v_Schwelle_Test nach Init 1x1
$01CFA PWG Schalter: PWG-Filterung b. Kupplung betaetigt 1x1

Can you help me find the right address?