Hi, I was hoping one of the many knowledgeable people out there could give me a shove in the right direction.

I am trying to raise IQ limits on a 2.5 TDI Audi a4 155 HP aym engine.

I know many people say limit is in pump not ECU but from what I have read the pump limit is higher than the 50.2 mg/str that ECU is limiting to.

I have raised 2 torque maps to bring IQ past 50.2mg/str, and have raised 11 single values of 50 which I believe to be single value limiters. But it has never exceeded 50.2 mg/str. I know it can be done and I must be missing something but for the life of me can't find it.

I know on the Ake engines there are three torque limiting maps and numerous single value limiters. I have found two of the maps and I think all of the single values on my dump but cannot find the third map anywhere (is it there)

Address for what ive found

4e6a2. Torque1
4d9ca. Torque2
52c46. IQ limit 1
52c48. IQ limit 2
52c4c IQ limit 3
52c56. IQ limit 4
52df4. IQ limit 5
52fa2. IQ limit 6
53158. IQ limit 7
540a2. IQ limit 8
54fc6 IQ limit 9
5522a. IQ limit 10
55234. IQ limit 11.


Obviously I have found many other maps. But these are the ones that relate to my issue.

Thanks for reading

i thin you missed 21*3 and 8*3 maps with 5000 values, there are limiters too

Hi, thanks for reply.
I think I should of been a bit more specific/informative. Of the maps that I've found, all the single value limiters are obviously single value maps. Of the two torque maps I have found one is 25x3 and one is 8x3. But after several hours of screen staring I still cannot find the 21x3 map I've searched in every way I know, but I'm still a begginer at this. It's taken a lot of time, reading and brain power to find what I've found, and I'm sure I'm close now. Any advice or ideas of finding it. The only image I can find of 21x3 map is for a Ake engine and Im sure I don't have any maps the same. Again any help is greatly appreciated.

hey.

if you give your file will be easier help you.

cheers

Thanks for reply. Files attached. Should of done that with first post sorry

4D90E 21x3 here is your limiter ;)

cheers

Wow. Thank you very much been trying to find it forever. Feel stupid now

Ashleymark wrote:Wow. Thank you very much been trying to find it forever. Feel stupid now

no problem mate. we are here to help each other ;)

Hello, sorry for thread up but I posted my problem here

audi-a6-2-5-tdi-bfc-0281011136-moded-file-t20434

and no lucky.

I can't find torque limiter. My engine is BFC and in winols and edc edit I can't find these addreses.

Hello guys. Can you help me where is that limiter 8*3?
I have All above i only miss this 8*3... With 50in.

Thx.