Finally.
I`ve done almost everything that i want with this car.
Can somebody look and rate it?
I`ve done maff off and made iq by map
Diagnostic limit granted to 56mg if i good remeber.
stock pump voltage was calibrated to 51mg with 4.5v, i extrapolated it to 4.8v which should give 54mg not sure is it possible with stock injectors, but if everything will be ok with this i will go to dynotest to check how its looking.
Also i granted soi little bit for 54mg.
turbo is set to 1.1 bar, and looking in logs n75 is around 76-82% and boost is stable in all range of rpms.
Does launch control will make problem to dynotest? its FWD without any ASR or ESP just ABS.
Can any one help me with deleting DTC for MAF?
Egr is off and start iq fixed.
now car is driving with 51mg. Im thinkig about granting SVBL to 2350 because turbo when spools gets overboost up to 2280, but there is no any safe mode problem. Just once, dont know why. I was handling with 100% wot and i release accelerator them drive with 30% +/- 30 secs and then when i tryied to accelerate, but car was on safe mode. just once, dont know why. 0 trouble codes. When it happend i was during logging car and boost was ~1800 and Dw TL was good Only SM was 46mg so its good with this boost but car was like 70ps.
All mods are done in 4x4 codeblock
Does i need something else to switch maf->map?
I made switch, Iq by map, and smoke limiter flat for 60mg.
Regards!

hey mate.

you wrote here lot info what is changed in file but not all changes i can find in file. in your file you flated iq by maf to 60 mg but iq by map is not touched, your maf/map switch is not touched, diagnostic limit is ori to 51 mg, in 4x4 block pomp voltage is ori etc. or you give here not your mod file or you must make more changes ;)

cheers, pozdro

yes its changed. Propably you are looking on wrong codeblock. i will add a screens with maps.

Ok, i found that winols did not saved changes. I attached correct file and map pack for those changes

MAF/MAP switch is wrong, pomp voltage is ori, diag limit 51mg. if you switch correctly to map sensor you should change boost correction by temp map .

cheers

Could You help me to find switch?
WTF... whats wrong with this winols and edc15 suite? when i open this file in edc15 suite and winols pump voltage is extrapolated to 4.8v and stock map is set to 4.5v. Dont know why it shows You stock 4.5 v becuse when i open file in edc15suite it show 4.8v..
Thanks for advice about correction by temp map.
diag limit propably winols dont saved i do this again later and post corrected file with diag limits.