SUPPORTS FGtech and KTAG !

It can be safely* used to flash the ECU. Bosch EDC17C46 BOOT adapter supports FGtech Galletto and KTAG. Precisly designed adapter for safe handlig that minimises the risk while connecting to Engine Control Unit pads.

Attention!
We offer 2 different dimensions of the adapter, L(large, 6cm wide) and S(small, 4cm wide) Please be sure that you are looking the right one. If you own non standard BDM frame with 4cm wide socket for adapter fitting, then you choose S, otherwise choode L.

No more tuning only over OBD, start real business and cover much more vehicles faster.
With adapter you can make full backup of the ECU in case that something goes wrong and you can than use that backup.

Technical specification
- supports Fgtech and KTAG programmer with switching mode with jumpers
- supports stable and precise connection - with 2.5mm PCB there is no bending
- supports stable and reliable connection with precise golden pogopins
- very good impact resistance and nice handling with smooth PCB rounded edges
- usefull marking on the PCB
- ground and +12V pins are marked for led lights
- external 12 V power supply can be used for LEDs
- 4 LEDs for very good luminosity
- very important cut out edges very close around the pinouts for great view while connecting to the ECU
- clear view of the ECU pads simplifies positioning of the adapter- adapter dimension: (L60mm or S40mm) x 60mm x 2.5mm
- adapter color: green with white print

More details at: http://www.ecubay.com/edc17c46-boot-adapter-l

I want to know the function of Bosh EDC17C46 Adapter. Could you tell me? Thank you a lot! :D :D :D

hi, it is boot adapter and it means you just press it to the board instead of solder resistors and wires.