Hi
I write once again and ask about help.
I have a newer soft in my Scenic 1.9DCI and my EGR is still working. I changed marked bit to 0 on the screenshot:

and no results.
I see, the EGR bit address in this soft is different then in my older. It is not 72696.
Anybody help me?

Regards,
Thomas

7283A

Thanks.
I've changed this bit to 0 and loaded to the car. Next, I plugged my car to ESI-tronik and tried manually (using built option) switch EGR and my EGR is still working.
Should I disconnect the power from EGR permanently?
When I had some older software and changed 72696 bit then EGR didn't work at all (power was connected).

try 72838 if no good try 72839

i just put your file through some egr remover software then corrected checksum in the file below if them switches do not work
you could try at your own risk good luck

Thanks redeye.
Your modification is not only change of 1 bit (switch on/off). I see, all map between addreses 73D70 and 73EC0 is changed. I don't understand this modification really :(

I try

Thanks :-)

Thanks :yawn: :yawn: :yawn:

redeye wrote:i just put your file through some egr remover software then corrected checksum in the file below if them switches do not work
you could try at your own risk good luck

this solution is wrong