1 Flash was succesfully with MPPS V12 with OBD... but car dosnt run because the Immobillizer was ON -> SAVE in Instrument
2 No more flash is possible
now i take the ECU out of the leon to flash it direktly to the pins but same its not possible to flash th e ecu again with mpps

MPPS Error: mpps required time delay not expired

How i Can flash the ecu to orginal again ?

Before I write the tuned file I saved the orginal file

Vw Software Number: 03G906018GP
System Type Number: R4 2.0l PPD1.2
Vehicle Vin Number: VSSZZZ1PZ8R116993
Bosch Hardware Number: 03G906018GP
Vw Software Number: 03G906018EL
System Type Number: R4 2.0l PPD1.2
Ecu found on K-Line



Vehicle Vin Number: VSSZZZ1PZ8R116993
VW Hardware Number: 03G906018GP
VW Software Number: 9953
VW System Type: R4 2.0l PPD1.2
VW Engine Code:
VW System Data:
Flash Attempts: 2 Times
Flash Programmed Ok: 1 Times

It will need to be recovered by BDM. If you can find a full bdm read that's compatible then great, otherwise you'll have to merge the OBD and BDM reads manually.

Very common occurrence with these cheap clone tools.

mpps is good for edc15 and edc16, but for other cars i use my kess mpps has lots of cars on the list but it doesn't flash them all.

My MPPS works very well to be honest.

Of course its the genuine article. That probably makes the difference.

It does PPD fine ;) Done some tricore too, EDC17, PCR2.1 etc.

Anyway, to the op - this ecu is going to need BDM attention to repair the flash, due to whats happened to it, that's the long and short of it.

Thanks i will check it on Weekend with new hardware.. to flash it with BDM

gunnar995 wrote:Thanks i will check it on Weekend with new hardware.. to flash it with BDM

hi, i responded to your email :)

Now It Works