by wicca » Mon Jun 26, 2017 10:58 pm
Hi Göran (sweden?)
Drivers wish: keep it original, exept 100% (use your row from your tuned file, its ok)
Torque limiter: Very safe, I would have it higher up to 4000 RPM and then decline from there.
IQ by MAF = untouched = still at default max = 60mg, so no matter how much more you want (66mg) you only get 60mg max (fuel cut)
EGR = off, super
Smoke limiter = if it was not your IQ by MAF and Duration maps who was limiting the car, you would see smoke at WOT ! I doubt you have calculate AFR for your 1050mg mass air column.
Injector duration maps = untouched = max durations possible is 60 mg then (the 2nd limiter for your tune)
N75 map = if you fix the IQ by MAF and duration maps to give more than 60 mg, I would advice you to close the last row in the N75 a bit (e.g 2% more to ensure you do not overstress the turbo at start atleast, then datalog it with VAG-COM/VCDS boost: specified vs actual, and adjust the last row from there)
Start of injection maps (all temperature range's) = standard = not nessesary to play with, if you keep it at 60 mg or less
Boost target map = standard setup but raised values -> could work, I would however not have that much air at 35-50 mg(remember fuel is actually cooling the internals where air is isolating, driving too lean will give extra stress to the engine), and I would have a 60 mg row instead (you could go with 2500mg boost at the 60 mg column to start with)
I guess your car is around 145-150 hp, with the existing file. This engine can easily do 165 hp (got the AVF myself)
/Wicca, Denmark