Hi , I have a question about DPF OFF in OPEL EDC16C9 ( 1mb flash ) 1.9 CDTI 120 8V hardware 0281012549 software A50359
Car has empty DPF with all sensors conected and working.
In ECU I set DPF as new ( reset DPF and reset differential pressure sensor ) by diagnostic tool and read ECU by BDM for DPF off.
In BDM file I do DPF off manually with Damos help ( without any DTC delete ) and write to car.

For 100 kilometers car drives ok ,no smoke, no glow plugs light , no errors in ECU ,static DPF regeneration by diagnostic tool not working ( good ).

But in diagnostic I can see parameter "Distance traveled since last regeneration" 80 kilometers ( increases with drive ) and "load state particulate filter" 6% and also increases with drive. Its good or bad ?
Becase of time I cant drive car for 100% load state DPF to check what will happen and what DTC will appear.

Is that a way to "cheat" and increase "load state particulate filter" sooner ( with less kilometers )to check what will happen ?

What DTC I have to erase or what to change to stop increase "Distance traveled since last regeneration" and increase "load state particulate filte" ??
Its good or bad solution ?

I HAVE THE SAME CAR ALREADY RUNING 2 Years DPF OFF AND I WORK ONLY WITH OPELS MOST OF THE TIME

I REMOVED THE DPF IN YOUR ORI FILE ... JUST UPLOAD IN THE CAR JOB DONE FOR SURE AND AFTER IF YOU WANT YOU CAN CHECK IN THE FILE WHAT IS BEEN DONE GOOD LUCK