Hi,

I'm looking into immo off for EMS2K on a rover v6 engine.

I've done two reads from two different ECUs. 1 via desolder and other through bootmode.

I've seen elsewhere online comment on 3EE0 to 3EEF set to FF should turn off but that's already FF on this ECU.

Setting 4000 to 7FFF should virginise right, similar to 32N?

Any advice on what to look for would be appreciated.

civste123 wrote:Hi,

I'm looking into immo off for EMS2K on a rover v6 engine.

I've done two reads from two different ECUs. 1 via desolder and other through bootmode.

I've seen elsewhere online comment on 3EE0 to 3EEF set to FF should turn off but that's already FF on this ECU.

Setting 4000 to 7FFF should virginise right, similar to 32N?

Any advice on what to look for would be appreciated.

4000 to 7FFF is for Renault, no listing for MG, but try it....

wbr

Hi Shooting,
Thank you for the response

Tried FF, on bench live data still shows immobiliser as active.
However all values on data set seem set to 0.

Is this zone an area for recording information then?

Does this sound more like it's been made virgin rather than immobiliser off?

Original
https://ibb.co/FzGrbJr
FF
https://ibb.co/FBVjfJL

civste123 wrote:Hi Shooting,
Thank you for the response

Tried FF, on bench live data still shows immobiliser as active.
However all values on data set seem set to 0.

Is this zone an area for recording information then?

Does this sound more like it's been made virgin rather than immobiliser off?

Original
https://ibb.co/FzGrbJr
FF
https://ibb.co/FBVjfJL

Immo in locations in my dump, but you must cut pin 58 or it will reset.
Try my dump again but with 58 cut




wbr