Opel Vauxhall Corsa B 1.0 8V X10XE Bosch M 1.5.5

by **KillMe3** » Sat Mar 30, 2013 12:18 am

Hello @ all,

i need help.
I have a Opel Corsa B with the X10XE 1.0 8V Engine.
The ECU is an Bosch M 1.5.5.

My Problem:
I think that the ECU is damaged. The Engine burn to lot of Petrol.
So ive another ECU one from another Car.
The Car wont start cause of the immo.
Is it possible to turn the immo off?
What shall i do?
If its possible i would flash my old ECU with the newest Soft.
Where is the newest Soft available?

Best Regards
KillMe3

by **Yoshimura** » Sat Mar 30, 2013 10:08 am

Look for 24C02 in the ECU. Immo is there. But after Immo off, if I remember correctly, you will need to disconnect the immo box and the receiver.
About update of the soft, I think that you will need Tech2

Regards

by **KillMe3** » Sat Mar 30, 2013 11:49 am

Dear Yoshimura,

i think you mean the ME 1.5.5 with the 24C02.
Ive the M 1.5.5 and like i know there is no 24C02.
I already orderd the Tech2 Interface. Now i waiting for dilevery.

Regards
KillMe3

by **Yoshimura** » Sat Mar 30, 2013 2:36 pm

The ME 1.5.5 is a hybrid ECU, and yours is normal Motronic

by **Yoshimura** » Sat Mar 30, 2013 2:58 pm

It could be also 27c256, but I don`t believe that...
Would you post the H/W number if you have a time. There is a chance that my soft recognizes only H/W numbers, not the model of the ECU

Regards

by **KillMe3** » Sat Mar 30, 2013 5:46 pm

The Number of the ECU:
964116 26SA5445
0 261 204 058
B 97 003
90 532 609

Regards
KillMe3

by **Yoshimura** » Sun Mar 31, 2013 10:23 am

Aha, got it! My mistake. I was thinking for other type of ECU.

Read this - http://www.codecard.lt/files/CARPROG%20 ... manual.pdf
It will helps you to understand what you need to do. In all the cases as I understand you will need the PIN code.

Good luck

Regards.

p.s. Some Alfa Romeo`s use the same ECU. I have some pics and schematics but for them. I`m not sure, is it possible to use ot on GM. But if you need them I will share :)