My first try on a decent reemap ( i hope) 306 hdi

by **ecuedit** » Sat Jul 20, 2013 9:12 am

Hi,
i have checked your original file from 306. It can be coded to use VNT control without any problems (factory settings).
It takes a lot of time to track your changes from bin that is not your original one.
Also the only right way is to use original bin, so i can not look at your bin closer because i do not have so much time, but if it would be done out of the original it would take 50x less time to check all.

by **dashmader** » Sat Jul 20, 2013 6:45 pm

ok i understand, but you can use the 406 original bin for camparing with the one i changed.
Or i could just try to activat the vnt control on my 306 original bin

by **ecuedit** » Sat Jul 20, 2013 8:18 pm

dashmader wrote:ok i understand, but you can use the 406 original bin for camparing with the one i changed.
Or i could just try to activat the vnt control on my 306 original bin

The file from 406 does not have same values in maps as 306 does, so it is not good thing to compare, you probably copied values from 306 maps, i did not dig into it.

Activate boost vnt control in your original bin and do it precisely if you want your project to be accurate as it has to be.

Here is the solution that i already posted time ago:
post135#p135