EGR OFF EDC16C34

by **Diestevar** » Fri Oct 25, 2013 10:56 pm

I'm going to disable the egr of my car. But in the past, i disable the egr with a blind gasket.
If i now make egr off in the ECU with the hysteresis map. I will continue having the error "Air above the setpoint measured"
Excuse me for my bad english but i can't translate the error better. In spanish is "Aire medido superior a la consigna". I can read the error with a LEXIA.

by **Biggie** » Sat Oct 26, 2013 1:06 am

please read here: egr-ford-focus-1-6-tdci-t2385

by **Diestevar** » Sat Oct 26, 2013 9:53 pm

Ok, thanks "Biggie" :D

After read it i think that, if i close the egr in the ECU soft. it can't give me an error because it is closed and it should not read the egr air passage.

thanks again!

by **HDLeo** » Sun Oct 27, 2013 9:12 pm

if you do egr off with hysteresis map, you will not get airflow error, but you can't disconnect your egr(and it should be in working order). If your egr is broken you'll get another error P0409

by **fodortms** » Mon Oct 28, 2013 11:32 pm

Try to replacement your broken egr valve: with a resistor to solenoid pins and a trimmer to set zero the egr position

by **toto607** » Fri Nov 01, 2013 12:59 pm

Any idea what Kind of resistor and trimmer it could be ?

by **saif** » Fri Nov 01, 2013 6:18 pm

are u have egr off exe???

by **toto607** » Fri Nov 01, 2013 6:36 pm

Are you asking for a way to disable EGR ?

by **Diestevar** » Sat Nov 02, 2013 12:08 am

Thanks to all! :D
The EGR valve of my car it's working ok.
I'm asking for the airflow error because in the past, i put a gasket blind to close egr. So if i close the egr with the hysteresis maps, i read that egr never close at 100% and always have a minimum airflow.
So the gasket blind never allow the minimum airflow.
is it truth? :think: