Disabling EGR EDC16U31

by **reinzg** » Tue Aug 28, 2012 7:31 pm

taktijs wrote:
reinzg wrote:on EDC16 in general and 'better to intervene on the control bits of egr rather than on maps duty cycle

And where can I find the controlbits for this ECU?

are after the map duty cycle, and tomorrow I look poiti let you know.

by **taktijs** » Wed Aug 29, 2012 12:35 pm

reinzg wrote:
taktijs wrote:
reinzg wrote:on EDC16 in general and 'better to intervene on the control bits of egr rather than on maps duty cycle

And where can I find the controlbits for this ECU?

are after the map duty cycle, and tomorrow I look poiti let you know.

Thanks in advance!

by **reinzg** » Wed Aug 29, 2012 6:32 pm

this and 'the file, with egr off, the password you send it in pm, if there are problems tell

by **reinzg** » Wed Aug 29, 2012 6:37 pm

with what you write the file? remember that you must correct cks

by **taktijs** » Wed Aug 29, 2012 7:26 pm

I use MPPS to write...I will correct checksum....thnx!

by **taktijs** » Thu Aug 30, 2012 7:09 am

Isn't the switch just 1 byte?

by **OdinEidolon** » Thu Aug 30, 2012 11:02 am

taktijs wrote:Isn't the switch just 1 byte?

Not that easy on edc16!

by **taktijs** » Thu Aug 30, 2012 11:07 pm

So it is à series of bytes in à row that need to be set to 00000?

by **RPM freak** » Fri Aug 31, 2012 1:08 am

He is setting EGR hysteris maps to 0.

by **borg123** » Thu Aug 27, 2015 3:22 pm

I know this is old topic, but still...

I was reading that on EDC 16 are 5 maps and that 2 and 5 maps need to be set to 0 to get EGR off.

Is this right?

Thx!