Working solution for EGR off EDC16

by **Fermon** » Wed Dec 18, 2013 11:51 pm

Thank you !!

by **2xded** » Fri Dec 27, 2013 1:14 pm

wacki_dani wrote:where i find the address for egr in edc16 c35, and how make it off with ecm titanium? tks adv

Similarly, as in WinOls. Most importantly, to calculate the checksum after editing.

by **silvano** » Sat Jan 11, 2014 6:54 pm

Will it work on EDC16C35?

by **dvdtuning** » Sat Jan 11, 2014 8:45 pm

post a sample edc16c35 file and see if I have a solution.

by **sershm62** » Sat Jan 11, 2014 10:08 pm

Thank for solution!

by **eddieddi** » Thu Jan 16, 2014 8:52 pm

Thank You ! very good info !
:thumbup:

by **GarageStarfix** » Wed Jan 22, 2014 5:31 pm

many thanx it should be very fine to try it.

by **bastunas** » Thu Feb 06, 2014 11:44 pm

Realy usefull, thx

by the way that is was based on, creadted on thich edc16xx ?

by **jojo1212** » Tue Mar 04, 2014 9:19 pm

thanks alot

by **juice** » Thu Mar 06, 2014 7:50 pm

rowly747 wrote:Edc15 easy just make the entire map the same value. If the highest number in decimal is 1000 then select the entire map and fill with 1000, done egr closed.

For EDC15 by putting the max value in whole table is not working man, is killing your turbo, is like you dont have any turbo.
Not sure why this but i can tell for sure because i tested. The logiq is correct , 1000 mg air mass all the time, but i think its going in limp mode because at idle , maximul air mass is 500 mg, and remains in limp mode.