can someone tell me how Galleto 2 Fgtech works?, I could only find software installation instructions,
How do I connect to ecu eprom, how do I connect the wires?
does anyone have a PDF or something else?

galletto 1260 is easier, everything works via the OBD socket.

I want to remove IMMO from renault clio 2 1.2 petrol engine, with airco, year 2000, ECU simens sirius 32
eprom 29F200BB ... I want to read /writing it bij OBD2 socket ...
which programmers can read and write the onboard bij OBD2 socket?

Best regards

update !!

find in the fgtechnology.it site. they have many instruction in pdf to download :)

paulo_ribeiro wrote:find in the fgtechnology.it site. they have many instruction in pdf to download :)

Thanks Paulo, that link is helpful, I've found these diagrams
JTAG Connection ( I give links because I cant uplaod image to this forum
http://www.fgtechnology.it/IMG_PROGRAMMA/esempio_jtag.jpg
Connection JTAG AUD Renesas for READ:
http://www.fgtechnology.it/collegamento_renesas_read.jpg
Connection Boot Mode Tricore:
http://img46.imagevenue.com/aAfkjfp01fo1i-18329/loc504/789325543_Immagine8046bcopiacopia_122_504lo.jpg

How can I know which connection I need ?

it's a helpful topic for beginners like me, if you want to share your experiences and your talent.
Thanks everybody who shares.

but have you shopping interface?
to read and write have to use this connection at boot mode
http://postimg.org/image/qcgo23p2l/

paulo_ribeiro wrote:but have you shopping interface?
to read and write have to use this connection at boot mode
http://postimg.org/image/qcgo23p2l/

I have not yet purchased interface
I collect information about interface, I have read that the EU version is better, I want to find a good address

would you please tell me I have good connection in this diagram? ? ( or my ECU is deaht now :D )

http://s7.postimg.org/3vjayp8ob/siemens_connection.jpg

12 volt socket to a 12 volt DC power supply? (Such as car batteries) ?
and which cable is K-Line ?
that Gray cable(boot cable) connect to anywhere?

the power supply it's like a phone charger for example.

to the k-line i think its a blue thread.the can high thread. but im not sure :(

the power supply can be the battery of your car.

Can anyone help me on how to wire up this ECU for bootmode?
Fgtech : ......to.....Siemens sirius32 ( without N )
Red ----------------> pin 29
Red ----------------> pin 30
Black ----------------> pin 3 ground
Green ----------------> pin 56 K-Line
I found info K-line is green but manual says green is ignition.

Yellow -----------------> pin 26 L-Line

where to be pin 28 of 29f200bb connected ?
to massa of PCB ecu ?
to black wire of galletto ?
to gray wire of galletto ?

http://www.picresize.com/images/rsz_1siemens_sirius_32.jpg

Thanks for info.

Red ----------------> pin 29
Red ----------------> pin 30
Black ----------------> pin 3 ground
Green ----------------> pin 56 K-Line (K-line is green)
pin 28 of 29f200bb connected to massa of PCB ecu (through a resistor 8-10 Kom) or to gray wire of galletto.
Good luck