Immo off IAW 59F M2

by **pitstopservvv** » Thu Dec 19, 2013 12:05 am

14 days ago I red the flash with mpps hardware on a Fiat Punto 1.2_8v and then I couldnt wrote back with mpps! So yesterday I bought Galletto master 2,peaked the file and wrote it!It wroted very nice at 100% the galletto stops respondening and there goes ecu bye bye :twisted: :twisted: :twisted: very nice...

Any way,I looked at immo off programs for new ecu and this is a hybrid ecu,very small,how the hack can I connect those 8 wires to read eprom and do the immo off!

Does any one has done it?!!

PLEASE SOME ADVICE!

by **pitstopservvv** » Thu Dec 19, 2013 9:22 pm

I bought today IAW 59f m3, and this m3 version is great because you put the ecu in boot mode, read the hole flash and then write back in boot mode, then you make the ecu virgin, no immo needed!

by **autoimmo** » Tue Dec 24, 2013 3:06 pm

Best way is iaw59 decoder. 2 minutes job

regards

by **mocPL** » Sun Apr 06, 2014 4:13 pm

The M3 unit doesn`t really have to be ''boot loaded'' to be reprogrammed.
The truth about the M2 unit is that these ECUs are incompatible with most of iaw decoders. A vast majority of an IAWdecoder programming hardware is simply cloned and doesn`t work correctly. Here i tell You why:

I just have learned my lesson about it.
I had a situation with a M2 ecu and tried to reprogram it with a cheap IAWdecoder clone, and that was obviously unsuccesful - programming session crashed - a programming software doesn`t close the data transfer session on the last part of write sequence, heavens know why - SIMPLY IV`e BAKED it UP , then i bought another one M2- BAKED UP AGAIN!!! , then i tried to cheat the central body computer on client`s punto using a M3 model reprogrammed to M2 software. That was a smashing setback - the client took his car on the road very content, then called me at the same day asking to tow the Punto back to the workshop - engine stopped for good. The remedy came on the next day, i bought an another M2 unit and took it to the guy miles from my town that have had an ORIGINAL iaw decoder.
After reprogramming using an original equipment the problem`s been resolved. I hope my story will save someone`s time and money.
Greetings from Poland.

by **matei23** » Sun May 18, 2014 1:27 am

I have an Punto 1.2 8v IAW 59F VG, what is the difference from M series? I want to make it immo off, I have onli normal programmers and a galleto master, what should I do?
Thank u