so can you please tell me how can i do it i cant find the bit 0 to 1 sequence
help please

Your ECU 15C5. I watched this connector block and found no control output VNT.

the ECU that you said it's not mine mi ECU it's bosh EDC15C and it have the vnt control because there is a map for it...
But I am speaking about the egr because when I switch of by values it gives an error so egr must be switched off by zero to one byte and I can't find it

Again, you bosh edc15c5 is 100%. Card VNT there, but no ECU pinouts. How to disable the EGR is also interesting?

Again mate it's not EDC15C5 ITS BOSCH EDC15C first commonrail version 1.9 8v 105hp JTD and I'm not shore about the pins but I will ask to a friend
Because I have a friend with n75 cotroled by Ecu map I told with vnt gt1856 mercedes benz is taking 194hp with electronic just nothing more

))) Watch carefully!
http://www.ecuconnections.com/forum/vie ... 21&t=20470

so i tried again finding the strain 0 to 1's ending in 048
this is what i find

it may be for dimmsport but not on the car i'll take it off again one day and send you the picture if you don't believe in it

but you probably are right mate must be missing in the sticker lol
and on the obd scan says the same EDC15C just that
since you have more knolegd than me i'll believe in you

On EDC15C7 have DAMOS forum. Where "Switch, M_air / P_air correction measure / calculate from P, T '= (048)