Sorry mate can't seem to understand you
Explain it better please

You wanted to switch to MAF maps MAP? Can signal wire with MAF sockets connected to the MAP sensor signal wire and edit map smoke. Since the maps are similar sensors.

I'm sorry but I can't understand the sentence you wrote
Want I wanted is eliminate maf sensor but for that the car must work by the map sensor or absule pressure on manifold sensor as I was saying I don't have the knowledge to do that can you send me your project file so I can see does maps because I font have damos for this ecu
Thanks in advance congratulations

I can not explain, because I have bad english.

Maybe you try write it in google translater it can improve perhaps I'm Portuguese my English its not so great either
Or try writing in your language and I'll Google translate it
Because I need this very much

Connector pinout MAF: 1 - Resistor meter air temperature 2 - Supply voltage onboard network (+12) 3 - Electronic weight 4 - Reference voltage (5B) 5 - Output voltage (signal ~ 1 - 5B)
connect the signal wire to the MAF sensor signal wire on the MAP sensor. Only the temperature sensor in the MAF need to keep working, and the other to turn off. A more empirically and by calculations correct map smoke in their firmware.

If i understood good thank you very much deman for the help I really need that

Where did you gett this sqematics about the pins on the sensor I need the same sqematics for the map sensor don't know what pin to use

Here are found in an auto parts store.

Sorry mate can you tell me the address of the maps you previous posted and teach me on how to alter them so I could do this for once thanks in advance you are giving me a lot of help