Newbie here please be gentile LOL

Bosch 5.2 1997 Ferrari 355
When I hook up galletto I can get writing permission but not reading
How would I go about reading the ECU?
I have herd to unsolder and read in it a reader but looking for someone that has played with the 5.2 soldered in chip, how to read it once out?
PLC88 sockets on hand to make the chip removable

Any help in the right direction is greatly appreciated

:)

It's possible it has a psop44 chip inside that's a 44 legged chip that you will need a eeprom reader to read it once hot aired off the board
You can then solder back on or put into a adapter that's soldered down and you can remove chip and put back in easily defendant on space this is useful if any mistakes are made the chip can be just picked out
You may also look at bench reading these ecu's I'm sure the gallettos have the pin outs