It was doing total normal flashing like 50 times before but after this i got some problems. When programming finished i noticed that fuel pump didn't make that ON-OFF sound like it usually does when reaching 100% of programming.
Then after i turned ignition OFF-ON again i noticed that immo light is ON and not going OFF. Also low pressure Fuel pump didn't start up like usual.
When checking things by LEXIA it wasn't able to communicated with injection.

So i studied forum i found that starting ecu to BOOT mode, it might start communicate with programer.

But i only have kwp2000+ cable, so my question is: Does any one had info how to work out with this cable during boot mode ?
Should i install some other serial programming software or how should i proceed ??