IMMO and VAG

by **Bugman** » Wed Sep 17, 2014 8:23 pm

What problems am I going to come across with the immobiliser on VAG engine ECU.

Can the immobiliser be switched off in the ECU as the engine is going to be used in a spaceframed car?

or am I stuck with the original key switch and cabin wiring?

Nigel B

by **vojko** » Sun Sep 21, 2014 10:16 am

no problem with immo on vag cars

by **darkelek** » Mon Oct 13, 2014 1:58 am

hello, what's the car and ecu?

by **umoussa** » Sun Nov 09, 2014 4:12 pm

Not all VAG Ecus can be turned off. For example, you can't immo off MM Ecus in all vag. But At least the Majority of Siemens and Bosch Ecus can be done.

by **tpzd3fq** » Fri Nov 14, 2014 10:41 am

umoussa wrote: you can't immo off MM Ecus in all vag.

Pardon me for a noob question :what's MM ecu? Motorola Mcu?
TIA

by **peikman** » Sat Nov 15, 2014 12:58 am

tpzd3fq wrote:
umoussa wrote: you can't immo off MM Ecus in all vag.

Pardon me for a noob question :what's MM ecu? Motorola Mcu?
TIA

MM Magnetti Marelli

by **Mintster** » Mon Dec 29, 2014 8:47 pm

Hi guys, I have a problem with my VW PASSAT B6 2.0 TDI 2006 SIEMENS PPDX ECU cannot get the car to run because the immobilizer control module is faulty not recognising keys and stopping the engine from running.VCDS Scan shows FAULT CODE ''P1570 ENGINE START BLOCKED BY IMMOBILISER'' is there any software that deletes immo from Siemens ppdx ecu and how can it be done? I have the MPPS tuning cable/software to read/write to ecu already. please help dont wantto pay 500 plus pounds to get new immo module and recode etc thank you

by **audi a4 b7** » Mon Dec 29, 2014 9:03 pm

It is not possible IMMO off on PPD

by **Mintster** » Mon Dec 29, 2014 9:26 pm

y Mintster » Mon Dec 29, 2014 8:17 pm
Hi guys, I have a stressfull problem with my VW PASSAT B6 2.0 TDI 2006 SIEMENS PPDX ECU cannot get the car to run because the immobilizer control module is faulty not recognising keys and stopping the engine from running. Had a VW specialist take a look at all wiring and individual parts of immo and he said its the immobilizer module that is faulty. VCDS Scan shows FAULT CODE ''P1570 ENGINE START BLOCKED BY IMMOBILISER'' is there any software that deletes immo from Siemens ppdx ecu and how can it be done? I have the MPPS tuning cable/software to read/write to ecu already. Tried both keys, shutting/opening all doors, reset ecu by touching battery terminals for 20 seconds etc but no luck :( please help cant pay 500 plus pounds to get new immobilizer module and recode keys etc
Plz help thanks in advance :crazy: