pin 28 of 29f200bb connected to massa of PCB ecu (through a resistor 8-10 Kom) or to gray wire of galletto.
Good luck
Thank you wery much,
I have tried it today, but no success
I have first 28 pin of flash eprom connected to the gray cable( with and without resistor),
...later to the massa of pcb
...and then to the black wire of Galetto
no one successfully
here's the pictures
I did not understand this message, " apply power toe the dashboard and remove ground to pin 28 of flash eprom end to continue,"
first in the manual say pin 28 must be connected to massa and now say REMOVE.. I have nothing removed, pin 28 stays connected to massa or gray wire.
http://s27.postimg.org/ef3ic68g3/error.png http://s9.postimg.org/lfj201ef3/error1.png