Please check my EGR off

by **jonti** » Tue Feb 10, 2015 9:55 pm

Hi,

First time for me :)

Please could you take a moment to check my EGR off?

The car is a kia rio 1.5 crdi, i *hope* I have flattened out the 4x 25x1 hysteresis related to the EGR.

Many thanks.

by **jonti** » Thu Feb 12, 2015 7:47 pm

The above file is incorrect, I believe those maps are torque limiter. The car started then immediately cut out.

I think I have found them (see attached file), it is 4x 18x1 hysteresis. Please could someone check my work? If it is wrong can you suggest where it might be?

Many thanks.

by **ecuedit** » Thu Feb 12, 2015 9:05 pm

Yes, you are right (i did little modifications in this post not to lead users to the same path ;) )
Those were Torque limiters, and limp mode torque limiter, check picture below.
When i come home i will take 15minutes and will take a look.

by **jonti** » Thu Feb 12, 2015 9:18 pm

Thanks for the confirmation ecuedit, i didn't realise it was also the limp limiter.

Thanks very much for taking a look I appreciate it. :D

by **ecuedit** » Thu Feb 12, 2015 9:20 pm

jonti wrote:Thanks for the confirmation ecuedit, i didn't realise it was also the limp limiter.

Thanks very much for taking a look I appreciate it. :D

i am on my way to PC, will help you with this ;)

by **ecuedit** » Thu Feb 12, 2015 10:15 pm

no ok :)
look for:

TWO 18 x 1 MAPS, here are addresses:
1C4F70
1C4FD6

press ctrl+g and put that address and you will be pointed to that addres.
make 18 col view and put start address to the begining and select complete map....