E46 320D remap advice

by **dunkler** » Sat Dec 20, 2014 6:04 pm

Hi Ecuedit members
I'm new to remapping and this is my first attempt to edit a ECU firmware to increase power. First of all and changed are made in winols and calculated in excel and finally made a fine tune again in winols to avoid spikes. I've tested this map, car runs well but it has a little bit high consumption and some black smoke which maybe someone can advice me on this issue.
1. I can't guess which map is at 3DCF0 and 3EB4C so I've not touched anything
2. Should I retune fueling map or smoke limiter map?
3. Should I touch N75 map? Maximum boost is increased to 2350mbar
4. Drivers wish inverted is not changed, do I need to edit for cruise control?

Car BMW E46 320D 136hp manual
ECU 0281 001 445

Thanks
https://www.sendspace.com/file/a5bm5t

by **adriancl** » Sat Dec 20, 2014 8:20 pm

Hi mate,
first of all , your "ori" is not ori.
Second-have you seen your DW map???why so agressive???
What do you expect from a such an old car???180HP, never without HW mods on engine.

DW.jpg

by **dunkler** » Sat Dec 20, 2014 8:42 pm

Hi adriancl
Thanks for your suggestion, that original file is what I've read from the car and I'm using as a backup file. I don't know if someone else touched this ecu. Driver wish is that agressive after I've seen other mods in another forum where they put an incredible 80mg :crazy: (probably the guy is crazy)
I'm gonna lower DW and remake fuel and smoke map and post the results
Thanks again!