Hi,

I have disable in address 6111f and in 7111f the EGR from 01 to 00. Before that I have remove the FAP (DPF) with ecusafe and I have uploaded the file to my car ( The car now is good, thanks to ecuedit ).
Now i would like to know if i have correctly disable the EGR?
And if the checksum is ok.

Here is the original file of the car:

resources/peugeot-406-coupe-2002-2-2-hdi-manual-0281-010-878/709

Here the file with (fap off) and the (fap off_egr off) :

fcardoso wrote:Hi,

I have disable in address 6111f and in 7111f the EGR from 01 to 00. Before that I have remove the FAP (DPF) with ecusafe and I have uploaded the file to my car ( The car now is good, thanks to ecuedit ).
Now i would like to know if i have correctly disable the EGR?
And if the checksum is ok.

Here is the original file of the car:

resources/peugeot-406-coupe-2002-2-2-hdi-manual-0281-010-878/709

Here the file with (fap off) and the (fap off_egr off) :

Hi. checksum must be changed. I do not see the file because it is not authorized, but it should do well.

ecusafe make the checksum on edc15C2 ....

[quote="fcardoso"]Hi,

Hi. EGR OK . CHK ok

The checksum is not good?
Ecusafe takes out the fap, but no the EGR, right?

Thanks a lot for you help.

Hi,
I have the same issue as fcardoso.

I already have removed the FAP from the ECU. Now I want to remove the EGR, so I modified the noFAP file manually.

Address 6111F: value 001 to 000
7111F: value 001 to 000

Now I'm not sure if the checksum is correct. How can I check it? I edited the .bin manually with an hex editor because the demo version of WinOls doesn't allow to export the bin file.

Can someone please, check if the file checksum is correct?

Original file: tgraudo_nofap.bin
Modified file: tgraudo_406_coupe_nofap_noegr.bin

Thanks in advance.

for this engine is not easier to blint EGR sensor by bearings ball ?

on PP2000 see errors but these errors do not cause power loss