hello everybody,
here is my first useful result, I think and hope! Before we start some basic data about vehicle etc.
CAR:
- Audi A4 8E B6 Avant from 2002
- 2.5l V6 TDi, 155 hp, Engine code: AYM
- Multitronic 01J, Transmission code: FSL
ECU:
- EDC15VM+
- VAG: 8E0907401
- HW: 0281010492
- SW: 1037363775
DOWNLOAD LINK:
- http://1drv.ms/1bh0iMO
REMAPPING:
- DRIVERS WISH Map
- EGR Maps (mechanically also turned off)
- SMOKE LIMIT Maps
- TORQUE LIMIT Map
- BOOST Map
- BOOST LIMIT Map
- SVBL
- N75 DC
- START OF INJECTION Map (copied from the 180 hp model, there is only one value different)
KNOWING:
As for the gearbox, I know everything! Because I bought this car with transmission failure and have this fixed in the past summer by hand. I know the gearbox, so to speak up in all items. The model-dependent camshaft problem are known to me. But this risk I take for me. As for the drive shafts, I already have the standard state, get three piece of broken. In short, I was already plagued this model almost every whim!
QUESTIONS:
- Do I wish the inverted drivers wish map must be adjust?
- How can I remove the Speed Limiter? Which should be at 155 m/h or 210 km/h, right?
LAST:
Everything which concerns the duration and crankshaft angle and injection behavior, I still have not really understood, and before this is not the case, I will leave it alone. I think it's better that way! That's why I first edited only the fuel maps. But would anyone want to tell me about my ECU are some tips and tricks or have literature and software to facilitate, then I would be very grateful!
Note, I do this all for me! Without any commercial objectives, which will remain so in the long term! I earn enough money in my job, so this only serves to expand my horizon!
Best regards
Daniel