how to remove immo from edc15

by **sparks** » Fri Oct 26, 2012 7:17 pm

how can i remove immo from edc15

by **mexanico1971** » Thu Nov 01, 2012 5:23 pm

what ECU ?! what car ?!

BR

by **youneselm** » Fri Nov 09, 2012 9:09 pm

post youre dump, i will do it for you!!!

by **tihiuvek** » Fri Nov 09, 2012 9:59 pm

If it is EDC15C2 Ecu with 3 connectors immo can be removed only in flash (AMD29F400BT) all other EDC15 can be done in eeprom (95160, 95P08...).
If you just wont to adapt keys for PSA group PIN can be calculated from eeprom - PIN can be programed to the ECU.

by **gezame** » Mon Nov 12, 2012 1:00 am

Hi
You are rigth.
EDC15C2 Ecu with 3 connectors immo can be removed in flash, but also sometimes possible in eeprom.
Br.

by **ecuedit** » Mon Nov 12, 2012 9:53 am

If you know how,
you can access to any chip in boot mode via minimon.

But the easy way is to take it off.

by **diago2002** » Wed Dec 05, 2012 5:36 pm

post your dump in immokiller and immo itis removed

by **Mr Whippy** » Mon Jan 14, 2013 3:50 am

tihiuvek wrote:If it is EDC15C2 Ecu with 3 connectors immo can be removed only in flash (AMD29F400BT) all other EDC15 can be done in eeprom (95160, 95P08...).
If you just wont to adapt keys for PSA group PIN can be calculated from eeprom - PIN can be programed to the ECU.

Hi tihiuvek,

So the eeprom contains data that is checked against the flash, so the data in the eeprom is like a checksum for the flash data too?

I'm a little confused about how the PIN is stored and used from single connector to three connector ECU's.

As far as I understood.

Single connector had coding for immo/security data on the eeprom.

Three connector sounds like it has coding for immo/security on the eeprom in an encoded form, which can be decoded to then be able to be written to the flash (if you need to)

So what are the impacts on the BSI? Does the three connector ECU use the flash to check the security code/pin, or the eeprom?

Does this mean if you write a different file to the flash on any PSA three connector ECU then the immobiliser won't work? Ie, you'd need to always edit the original file if remapping?

I assume in this case that the security data pin/code is still on the eeprom for BSI coding...?

Thanks for any clarification you care to share!

Many thanks

Dave

by **dj_max84** » Mon Feb 04, 2013 4:13 pm

hi!
on most VAG edc15 i worked on it was possible to disable immo by simple vag-commander 1.4.
sometimes it was giving the immo light on the dash but immo was disabled successfully.

by **slashamet** » Mon Feb 11, 2013 7:52 pm

Hi , I've a 320d e46 bmw 136hp,
when I use ECM2001 the software shows me instructions to create a *.MIX file... What is it??

I've used galletto to load the map, and the driver B445887X.DRV

Thank you!! :mrgreen: