EDC16C39 Fiat Croma 2,4 JTDM Help FLAP

by **Elo** » Fri Oct 31, 2014 8:25 am

Hello. I need help on my car Fiat Croma 2.4 JTDM (ED16C39) broken swirl flaps. Physically, I turn them off but I want to disable in the firmware. Please indicate the address of the card where it can be done.

by **slackwar3** » Fri Oct 31, 2014 3:03 pm

Elo wrote:Hello. I need help on my car Fiat Croma 2.4 JTDM (ED16C39) broken swirl flaps. Physically, I turn them off but I want to disable in the firmware. Please indicate the address of the card where it can be done.

Did you remove it completely including servomotor? If not and you have plugs still connected you just need to change duty cycle map, if you have it all removed you will probably need to change additional values to disable diagnostic as it will give error on dash if plugs disconnected (no signal).

Best regards

by **DW1976** » Fri Nov 07, 2014 11:51 pm

hay
disconet swirl activation+hysterezy swirl+dtc ist good
regards

by **gmzed** » Sat Nov 08, 2014 4:57 pm

slackwar3 wrote:
Elo wrote:Hello. I need help on my car Fiat Croma 2.4 JTDM (ED16C39) broken swirl flaps. Physically, I turn them off but I want to disable in the firmware. Please indicate the address of the card where it can be done.

Did you remove it completely including servomotor? If not and you have plugs still connected you just need to change duty cycle map, if you have it all removed you will probably need to change additional values to disable diagnostic as it will give error on dash if plugs disconnected (no signal).

Best regards

Anyone know how to do that ?

by **slackwar3** » Thu Nov 13, 2014 8:59 pm

gmzed wrote:
slackwar3 wrote:
Elo wrote:Hello. I need help on my car Fiat Croma 2.4 JTDM (ED16C39) broken swirl flaps. Physically, I turn them off but I want to disable in the firmware. Please indicate the address of the card where it can be done.

Did you remove it completely including servomotor? If not and you have plugs still connected you just need to change duty cycle map, if you have it all removed you will probably need to change additional values to disable diagnostic as it will give error on dash if plugs disconnected (no signal).

Best regards

Anyone know how to do that ?

I can do it if you need.

Best regards

by **ddnc** » Tue Mar 10, 2015 12:12 pm

Look for "Anwendungsparameter für variable Drallstellglied Diagnosesignal" 1x1 in damos. Didn't test it but might be one single switch.

by **Elo** » Wed Jun 10, 2015 11:26 am

Hello! I'm sorry that I have made the topic and did not respond to messages. I'm just out of Belarus and do not speak English, so I write with the help of google translayte.And I do not think that I understand and I will answer. Thanks You. Now back to my question. I removed the flaps but not blocked actuator connector, so there are no errors, but would like to improve the working card. I would be very grateful if you help me to do it.