I/O Terminal Tool

by **eagleone** » Tue Sep 01, 2015 7:59 pm

I have been looking at this tool as it can read mpc over obd on several ecus.

However it reads flash, eeprom and mpc individually. How can one then create a bdm2go file ?

by **kennfeld** » Tue Sep 01, 2015 11:33 pm

why create a bdm to Go file with it ???

by **eagleone** » Thu Sep 03, 2015 10:28 am

Was at the time of posting trying to ubderstand the difference. Have since found out the bdm2go contains all the ecu areas , whereas i/o lets you access and save them individually

by **TricoreMan** » Sat Sep 05, 2015 12:38 am

what does mpc stand for?
which interface is requiered for io terminal?

thx

by **eagleone** » Sat Sep 05, 2015 7:39 am

TricoreMan wrote:what does mpc stand for?
which interface is requiered for io terminal?

thx

As in MPC555 processor traditionally done on the bench using BDM but this little I/O Terminal Tool lets you access the MPC555 over OBD! And it works great.

You buy the tool and then you purchase a SIM card for each ecu plugin you want. in my case I have Denso and siemens.

The developer has a Bosch plugin (limited coverage but growing under each release) , Magneti Mareli etc.