failed flashing ME7

by **ing90** » Fri Sep 11, 2015 9:21 am

Ok, I'm going to keep my hand off from the EEPRom.

I reflashed it again. I'm quite sure I'm in boot mode, because MPPS set a fault if not.

But no engine start. Interesting: with the PSA software I can readout the fault memory of the ECU, and there are a few like injector fails, but I am not able to start a component test...

I re-read out my flashed dataset, and all 512KB are exactly the same as in the original .bin

Should there not be any changes on the 29F400BB, as example because of the new faults?

I'm at my wits' end... :/

by **ing90** » Sat Sep 12, 2015 12:37 pm

Just as information for other guys with similar problems.

I had to desolder the EEPROM from the old ECU and replace it on the new one. Now the engine runs.

The immocode is read out from there.

Regards,
Ben

by **CarTuning** » Sun Sep 13, 2015 2:55 pm

ing90 wrote:Just as information for other guys with similar problems.

I had to desolder the EEPROM from the old ECU and replace it on the new one. Now the engine runs.

The immocode is read out from there.

Regards,
Ben

You got car finally running, good work !

by **ing90** » Thu Jan 14, 2016 9:52 pm

Hey all,

due to I was ask, the pin out seems to be the same at least until DAM9898:

32pin connector:
no pin for flashing
48pin connector middle:
H2 - K-Line
B4 - +15 (ignition)
48pin sideward:
L3 - +30 (Bat)
M4 - ground

Regards,
Ben