Hi again Guys,

After doing some tweaking on my friend's car, I decided to also give it a go on my own Focus 1.6TDCI.
However, compared to my friend's car, which was an EDC15P+, this is an EDC16C34.
Attached are the original and modified bin files, hope someone can have a look and let me know if I missed anything or if I did anything wrong.
Map also includes EGR (hysteresis) off and DPF (switches) off.
I haven't touched the Driver Wish, Duration and NM to IQ maps, as I think they should already cover what I'm doing. Only modified torque limiters, SVTL, Boost and Boost limiter maps, Lambda, Rail pressure, SVRL and Rail limiter.
My aim is around 300Nm and abut 130Hp in the end.

Ok, so I've finally uploaded the map to the car and did a test run with Forscan recording. I can definitely feel an improvement, but I'm guessing it's because of the disabled EGR which now reports 0% for valve position (I'm guessing that is closed).
However, the "Net Engine Torque" reported in Forscan does not appear to go over 240Nm, no matter how hard I push the car. I'm guessing I'm missing some limiter, but I can't figure where.
I can see the MAP going up to 2.4Bar now, and the Rail Pressure up to 1500 (a bit low, should be around 1650).
I've got two torque limiters, one single value, 6 for gear speeds, one for revers gear, one with atmos pressure and engine speed and another one with atmos pressure and vehicle speed. Is there another one which I can't see?
Any answer would be highly appreciated.

LE: Right after the torque limiter with atmos and rpm (1C92DC), I can see 8 values set to 02400 (16 bit decimal). Any idea what these could be?

Please close the topic!