alh golf 4 tdi 90hp

by **jeffy1978** » Mon Mar 07, 2016 10:34 pm

Hi,

Please rate my "tune"...

http://www107.zippyshare.com/v/pivGdGyG/file.html

also could someone help locate codeblock start-end address

vagsuite says
54000-5ffff id=5f776
60000-6bfff id=6b776
6c000-77fff id=77776

looking at the hexdump in winols ids look correct but start and end do not
i want to make all codeblocks manual

thank you in advance for any help

by **fil1234** » Sun Mar 13, 2016 8:37 pm

dw map should have more high values that smoke map torque map should have low values that smoke and dw map
not good make new file

by **jeffy1978** » Tue Mar 15, 2016 1:17 am

Thanks for the help fil1234

I will fix it and repost

by **czerkam** » Thu Mar 17, 2016 3:29 pm

Also boost map and boost limit map should be corrected. Limits cannot be lower then thresholds in boost map :)
you can also add some more fuel in DW in aread from 65% up to 100%.
torque map could be corrected to put less IQ in lower rpm part. 1500rpm ~ 40mg/str, 1800 ~4300mg/ and with std. injector nozles not more than 52mg/str.
smoke map - increase X-axis to get more air. because currently you'll have a little bit of smoke.
increase svbl because it's still stock.

regards

by **jeffy1978** » Thu Mar 24, 2016 12:31 am

thank you czerkam

Very good input it's my first remap, havent had a chance to fix it yet, I have been watching the youtube videos by vagecumap and reading the vp37 guide I found on here before I go back at it.

would 52mg/str be the max with stock injectors and 11mm pump and what would be safe values for the svbl I didnt want to play with the turbo maps to much, i just replaced it last summer and was a little scared of grenading it.

by **jeffy1978** » Thu Mar 24, 2016 1:07 am

Ok guys I hope i did better this time. I followed both of your suggestions :D and compared my boost maps with a passat 115 file

by **jeffy1978** » Sun Mar 27, 2016 7:23 pm

ignore my last post/file turns out I overwrote my file with the one I was using for comparison over my file woops :roll:

here is my real file

by **fil1234** » Sun Apr 10, 2016 12:16 am

try and report.bin

by **jeffy1978** » Mon Apr 11, 2016 1:22 am

heres a new one I tried today felt pretty good and only a little black smoke at Wot. i will try yours tomorrow its getting dark here like to see if there is any smoke . thanks very much for all your help

by **christiandoy** » Mon Apr 11, 2016 1:32 am

Hey man,

What kind of power are you after?

Are you looking to delete EGR?

I am noticing a lot of the times you are not consistently changing all the codeblocks to reflect your changes.

You have only changed 1/3 driver's wish maps to your desired values.

Do you need help finding the other maps?