No one to rate my tune??? :(

:) post original, tuned and mappack and i will take a look,
there is a problem with time, so you have to serve all files in zip than i can take a quck look.

Thanks Ecuedit :)

Here is original, map pack and tuned file.


thanks for your help and comments.
B. Regards

What you have modified so far is not so very bad, but need a lot of more work.
You have to make complete mappack, you have located only basic maps.

You can do turbo better, to preserve good consumption.
MAF - you will have big consumption again, do not go so low with airflow columns modified...

Drivers is not OK, you will have big consumption like this...

You can do some work on n75
You can extend duration map to iq90
One boost limiter is not done...

Rail? :)
SOI?
Pilot?
SVBLs?

You have now enough work to do.
cheers

Thanks Ecuedit.

i will change the things you say. I am driving with this tune from 2 weeks.
I will raise rail pressure to 1400B and make an IQ90...

Whit the file now how much power and torque do you think i have?

In excell my calculations says 373Nm but the power is 193hp ( i dont believe in this value....)

B.Resgards and Thanks again.

This file does not produce so much power :)
You have to do changes properly to get proper ID calibration as well than the calculation can be done to -+2hp proper.. .)

And you can not get so much power with stock turbo...

Yes you are right. In max. this file gets 170hp.....
I have to work on it more to get better consumption, and to be well done.

thanks.

fcardoso wrote:I will not change injecction duration map, the rail pressure has raised in 50bars, so automaticly if the duration map still the same, i gonna inject more fuel cause the duration still the same rigth?
BRegards,
Filipe

No, you will only advance EOI, because it will take less time to inject same IQ.