Hello all as I mentioned in my introduction I am very new to the tuning and software part of automotive scene. Had a few questions regarding some hardware I would like to use with this audi TT AWP I'm working on, A little of back story to help you understand my situation. The TT I'm working on is a race car which was running Motec stand alone ecu, owner of car decided to remove Motec to use on other race car, original ecu of tt is long gone and I was wondering if ecu mentioned in title (Bosch ME7.5 06A 906 032 HP) which is for a 1.8t 20v engine as well can be used. I'm taking these opportunities to dive into an area I have very little experience in, but like other things I have done in the past I'm very enthusiastic about learning thoroughly the software and tuning aspects of modern cars. which brings me right into the other part of my inquiry the Bosch ME7.5 06A 906 032 HP ecu also has an immobilizer and am like I mentioned before, taking this opportunity to learn more. I plan on buying equipment necessary to remove immo by reprogramming smd chip this is the equip I am planning to purchase please advise me if I need anything else.

1. GQ PRG-1123 GQ-4X V4 (GQ-4X4) programmer + ADP-099 adapter + ADP-081a SOIC adapter for GD25LQ64 25LQ64 25A512

2.2in1 878ad Soldering Iron Rework Station Hot Air Gun + Tip + 3 Nozzles Heat Gun Holder Welder Yihua

also would like to start tuning Petrol VAG vehicles list of recommended software and hardware would be greatly appreciated. At this momment all I have for hardware is MPPS and software WINOLS and VAG EDC15P suite.

I thank you all in advance for your patients and your quick response with and to my newbie questions.


Thank you all Jose I

You can read eeprom by OBD in boot mode with a galletto 1260 or even VCDS in dump mode.
For this type of ECU MPPS or Galletto 1260 is enough to program in boot mode or directly by OBD (For example i have 032AF and 018CH and none of them works by OBD, just on table in boot mode). If the ecu fits into original harness, than you can use it. If old ecu was Bosch ME7.1 and you try to fit ME7.5 will not work. There are differences in harness.