Ok now, i think im being really dumb here. But I cannot see a 95160 eprom on the board. I only have the rear cover off (with the bdm pads) and non of the chips are 95160.

Anybody point me in the right direction?

I've tried all the 8 pin chips on there and none of them want to work for me

This is what i have in front of me

Ok with the help of a hammer and screwdriver i got the case off and have pulled the bin from the 95320 eeprom.

Is it actually possible to defeat the immobilizer on this ecu?

Yes. In 16C9 can disable IMMO . Immo eeprom is on the other side of the board ) ) . Its easier to read through the BDM! IMMO Also , you can disable the flash and 2Mb.

Deman wrote:Yes. In 16C9 can disable IMMO . Immo eeprom is on the other side of the board ) ) . Its easier to read through the BDM! IMMO Also , you can disable the flash and 2Mb.

I've got a bin from the eeprom.

Do i also need to disable immo in the flash as well as eeprom?

I've attached the eeprom. I was hoping it might be simple like me7.5 but looks like i will need some sort of software to get it off. Do you know what would be best to use?

The eeprom can be cleaned under the binding.
And remove IMMO only in Flash , using the software.