Working solution for EGR off EDC16

by **saerg** » Fri Dec 02, 2016 4:39 pm

very usefull and many thanks

by **puggiblue** » Sat Dec 17, 2016 7:22 pm

dextuar wrote:Hi everyone,

can anyone help me find where the erg hysteresis maps in my file are? According to the guide I can't find similar looking map. The car is E90 320d with a M47TU2 engine. Thank you!

Hi. In Your file hysteresis maps is:
C900A - 16x1
C9070 - 16x1
Change all values in these maps to 0 (zero)

by **xsport** » Mon Dec 19, 2016 10:21 pm

Hi i try to off my egr on MB Sprinter w906 2.2 311 EDC16CP31 1037381071

1037381071 311 2.rar

by **_Marco_** » Mon Feb 06, 2017 1:16 pm

Hello everybody
I'm looking in my ROM for the hysteresis EGR MAPs.

Unfortunately the Structure of the .bin seems to be different than in the information I could find so far.
Maybe someone could support me. ;)

by **Bandit** » Wed Feb 08, 2017 7:02 am

Hello I have a 2005 W211 USA spec E320 CDI

I have had some help with disabling EGR and swirl valves and when I check in the SDS diagnostic system, the EGR is indeed off and stays off (SDS actually reads 5% but it is essentially off). However, when I accelerate at wide open throttle, the car goes into some kind of limp mode and feels like it has a severe lack of power. There are no DTCs reported and when I turn off the engine and turn on again, the car is back to normal. As soon as I accelerate at WOT again, the issue happens again. When I reflash the original ECU file, the issue goes away completely.

Does anyone have any thoughts on this? Thanks!