Help Bosch Med 9.5.10 Bricked

by **elocatel** » Sat Feb 17, 2018 4:46 pm

Hi,

I have an Audi a3 8p FSI 2.0 , it has an Bosch Med 9.5.10 ECU.

I was writing a modified file using ODB2 with Galleto 1260 and computers hangs, so the ecu is bricked, car does not start.

Before that, I did a backup of the ecu (File size is 2 MB), I'm aware that put the ecu in boot mode shoud work, but I'dont know which pin shoud I ground.

I have seen many examples talking about pin 24, but this does not work on my ecu.

My ecu has a M58BW016 flash chip, which pin is the correct one?

Please help!!

Regards,

Enzo

by **Shooting** » Sat Feb 17, 2018 6:13 pm

elocatel wrote:Hi,

I have an Audi a3 8p FSI 2.0 , it has an Bosch Med 9.5.10 ECU.

I was writing a modified file using ODB2 with Galleto 1260 and computers hangs, so the ecu is bricked, car does not start.

Before that, I did a backup of the ecu (File size is 2 MB), I'm aware that put the ecu in boot mode shoud work, but I'dont know which pin shoud I ground.

I have seen many examples talking about pin 24, but this does not work on my ecu.

My ecu has a M58BW016 flash chip, which pin is the correct one?

Please help!!

Regards,

Enzo

BDM reader is best way.. your 1260 is not a good tool btw... Get a real tool..

wbr