Hello everyone,
Few days ago I wanted just to READ my edc16c3 Renault Scenic 1.9dci ECU with MPPS V16 clone. Just for educational purposes. It read VIN number and injector codes and saved to *.noz file. Right away it got some error and did not read anything else. After that moment ECU dropped VIN number and injector codes and went to limp mode. Tried to set new injector codes with Delphi but with no luck. I thought it wont be any worse if I'll try to WRITE someones original file from this forum. Well, it did. Selected previously saved noz file and it said that writing was done successfully. Now my car won't start.
What exactly I did wrong? And what should I do next?
Probably everyone says that but... Please HELP :?

Do you have any comunication with ecu over obd2 port?

Yes. Delphi says its unknown ID system, but MPPS can ID it and write again.

When I switch ignition ON the cooling fan kicks in, shows low battery and low oil pressure warnings in the dash...

Write original file for start, then try to get your hands on renault clip to make injectors programing

That's the worst thing.. I don't have original file from my ECU... It failed to read...

This complicates things...alot....do a full bdm read , and post ecu ID

What tools should I choose? Asking because at the moment I don't have any. Would galletto master clone work? Ecu is edc16c3.
Thanks a lot.

Any advise?.. Please understand me right, I'm not trying to open a busyness. Just want to make my car running again.
Thanks

Don't use pirate interface, with no idea what are yo doing. This is the major hint.

:clap: