gteam wrote:immo is already done without a problem.but i only have mpps tool and cant do checksum on this files before writing so thats why i can move forward and file what you have sent me yesterday wasnt working,had error during flash

Yes because it's a different SW number, for another car.
Now I see this, you need to just flash ORI as this was already in your car.
Checksums on ORI are fine, just flash it.

wbr

thank you.ll try it tmw as too late now.hopefully it ll work and i wont f....ed up new ecu with file from my previous/ori / ecu file

just want to be sure, so it is ok to write ori file from my ori ecu to this new ecu which is from a diffenent car but same type?

Sorry im bothering you again.tried to flash ecu with my ori file.at the end on the flash i got message block checksum error. i think ecu is gone.any advice? or do you know anybody who can put ecu into a boot mode and write my ori file what i need? thanks

gteam wrote:Sorry im bothering you again.tried to flash ecu with my ori file.at the end on the flash i got message block checksum error. i think ecu is gone.any advice? or do you know anybody who can put ecu into a boot mode and write my ori file what i need? thanks

What MPPS do you have? if it's a clone then anything can happen.
If the same HW is used then you can use ORI SW.
Use recovery mode and re-flash again, should be ok.
If not then you'll need BDM/Boot-mode read from ORI ECU then write via BDM/Boot-mode on new ECU

wbr

im using mpps v13. there isnt recovery option only generic option but doesnt support edc17cp14 ecu so not good.as i did little research only way how to put this ecu into boot mood is to open it and do something inside which is quiet complicated for me

gteam wrote:im using mpps v13. there isnt recovery option only generic option but doesnt support edc17cp14 ecu so not good.as i did little research only way how to put this ecu into boot mood is to open it and do something inside which is quiet complicated for me

I've sent you a private message

wbr