megapage wrote:

Shooting wrote:
Yes we need original, but checksums are fixed now... your file has strange bits edited outside of the map area, this is why it isn't working.
Here is Original for your car, I suggest you start again.

Nop.... still no checksum found on origin file from You. :x :x :x

I wonder if this is due to the fact that I connect via the ECU from the 3.0 TDI (vide screen). My guess is that the controler (computer) was swapped to my 2.0 TDI, but I read .BIN from it, so It should write it down (?).

Summa summarum, I can not connect to the car by any other driver available for the MPPS V13, than the one for the 3.0 TDI, who does not see checksumm on any of my files, or those from you.

Any suggestions?

Maybe it's your fake tool, I gave you an original and it checksummed ok for me.

wbr

I bought the 5.017 interface and Kess v2 2.47 program. The program, unfortunately, does not read the ECU, but it gives you the option to write. Shooting sent me the original file. I removed DPF via ECUsafe2 and tried to upload the file via Kess. Unfortunately, Kess informs about the checksum error (both on the original file from Shooting and on where DPF was successfully removed in ECUsafe2).

Any ideas what's wrong? Maybe I need to record some special name or extension before writing ECU in Kess? Why does the original file (form Shooting) also cause a checksum error? :oops: :oops: :oops: :oops:

Audi A4 Avant B8 2008 2.0 TDI CR CAGA

Kess ecu info:
HW:
SW:
VIN nr.: WAUZZZ8K09A100434
SW ver.:
Spare:
Engine: R4 2,0L EDC
HW Ver.: 03L906022B
SW upg.: 03L906022JM 3173
Installation: EDC17 CB.02.05.01 C16.00 P531

I think that is a bad ideia to use MPPS v13 or Kess on those ecu..
Use at least Ktag.. even clone can do it