EDC16C34 PSA

by **casianoros** » Tue Nov 19, 2019 6:20 pm

Same thing on edc15 (y) maybe the 1 rpm gap is to fast try 4 it works fine on my pug at 5800 :thumbup: :thumbup:

by **jurebv** » Tue Nov 19, 2019 6:45 pm

best is 5 rpm gap on torque limiter then cut off NM2IQ or duration on 1gap, also retard SOI alot on that RPM ;)

by **dangell88** » Fri Nov 22, 2019 5:31 pm

jurebv wrote:best is 5 rpm gap on torque limiter then cut off NM2IQ or duration on 1gap, also retard SOI alot on that RPM ;)

jure do the same rules apply for edc15 16 and 17's

by **Faster** » Fri Nov 22, 2019 8:36 pm

Here is your file with Hard Cut at 4500rpm try it and tell if it works

by **Adri19** » Sat Nov 23, 2019 11:33 pm

And yes... this EDC16 has SVRL, i've found it is a little before the TL maps
Here's a test with the svrl at 4500
https://www.youtube.com/watch?v=MxsVDdB-XIs

It works also with the TL map, but i wanted to do it with the svrl

by **Faster** » Sat Nov 23, 2019 11:42 pm

Adri19 wrote:And yes... this EDC16 has SVRL, i've found it is a little before the TL maps
Here's a test with the svrl at 4500
https://www.youtube.com/watch?v=MxsVDdB-XIs

It works also with the TL map, but i wanted to do it with the svrl

Why not say this is my file?

by **Adri19** » Sun Nov 24, 2019 12:19 am

Because is not... your file was "no read" i couldn't see what modifications was made, since i had my file already remaped and i "provide" the stock one, your file unfortunately was no use to me in this case
But i highly appreciated your help