seat leon stage 3 map issue

by **j0nesy** » Fri Jan 03, 2020 5:31 pm

i was just wondering if anyone could help me out with the map thats on my car
car is seat leon 1.8T 05 plate with stage 3 has the following
Custom 3" turbo back exhaust
Forged rods
Front mount inter cooler
Over sized 80mm intake with ram air filter
610cc injectors
Dw65 fuel pump
4bar fpr
3bar map sensor (have 4bar available to switch out)
Vt262c hybrid turbo (AET built)
High flow manifold ported to match new turbo
The current map has flat spots in 4th 5th and 6th around 4.5k and map just feels shit
i have attached the map but as described its not running as good as it should
if anyone can look at the map and see any reason why its running bad that would be great

by **jurebv** » Fri Jan 03, 2020 6:29 pm

this file cannot be done over internet...problems waiting to happen....requires alot of logs...best done live at dyno...

Best Regards

by **j0nesy** » Fri Jan 03, 2020 9:43 pm

it was done at DDG traford park on dyno left it with them for a while but still not right thats why i asked on here just to see if anyone could see why it has flat spots in top 3 gears it was better before the upgrades that cost a fortune

by **NRT** » Fri Jan 03, 2020 10:57 pm

j0nesy wrote:it was done at DDG traford park on dyno left it with them for a while but still not right thats why i asked on here just to see if anyone could see why it has flat spots in top 3 gears it was better before the upgrades that cost a fortune

Your tuner needs to sort the problem out or give you refund. Post your Ori too.

by **jurebv** » Sat Jan 04, 2020 7:20 am

Atleast post some logs with vcds

by **waynemodz** » Mon Feb 17, 2020 8:52 pm

post logs...

Id suggest you put the 2.5 bar map sensor map and see if the flatspots go away

by **haddumex** » Thu Feb 27, 2020 7:27 am

Post your ori file, for those mods you wont see any Good maps without logging and a few map revisions

by **haddumex** » Thu Feb 27, 2020 7:38 am

KFMIOP/KFMIRL not properly modified, LAMFA way too rich at high rpm, missede some limiters, Car drives like shit because KFPED was modified extensively but super limited except at high rpm, so super limited at basically every pedal positions except 100%, the "pops and bangs" added dont match load areas between KFZW and a KFZWMIN as well as he missed KFZWOP maps and didnt change overrun fueling, quite a bit wrong here, but my bet on shitty driving sensation is KFPED map all over the place and throttle cuts probably