I've made an attempt to generate some more torque in my mate's trafic. Given the (lockdown) situation we are in I just did everything based on excel and have not datalogs (yet)

I have done a edc15c2 before but this is just a tad different.

What I have tried to do:

Upped the turbo map by approx 0.2~0.3 bar mid range and adjusted the turbo atmo limits too
recalculated the AFR map to 17:1 lower rpm range, adjusted the axis to 1050 mg.
upped the Drivers wish, upper half (50%+)
adjusted the main TQ limiter and gear depended limiters.

The main goal is to get near 73~75mm3 injected to get from 100hp stock to a nice 120~125hps ish with gain of torque between 1500 and 2500, but he likes to rev the whole range from idle to max rpm towing trailers and caravans.

I hope I found all limiters allowing it to inject ~75mm3 but Im not sure about this map:

https://imgur.com/a/AUWsuaK
It also contains the maps I found.

It looks like a limiter to 65mm3 but it doesnt ring bell. The EDc15c2 had oil and fuel temperature limiters but havent found these in this ECU.

I would appreciate some feedback, I hope its not to shitty :)

Hello.

I do not know what software have you used.
If it was winols, please, upload the project to see your modification.

Best regards