Hi All,

So I have a BMW E46 320D I assume the EDC15 ECU as I don't have the MS42, MS43 etc...

I can get fault codes using BMWLogger but I am unable to read the ECU File using Galleto or BMWFlasher; the BMWFlasher just says "Attempting to Connect" and then the writing disappears and it goes back to "D-Can Ready"...

Galleto just say's "No Interface found"...

BMWLogger comes back saying "Unable to send packets to ECU" but it can retrieve codes?

Could this mean I cannot Read/Write to my ECU or is there a way to configure STD:OBD interface for Galleto or something... I'm stumped!

Got a look inside if there is plcc and than recheck galetto can read, write them .