M3.8.3 POP and bangs + rev limiter modding

by **Rust** » Mon Sep 28, 2020 9:41 pm

Hello everybody

I have bought this old passat V5 wich, and due to a bad case of rust, the old lady will be dead in a short time, i have read the flash file from the old M3.8.3 ecu and posted it here....

Is it possible to make pops and bangs and raise the rpm limit a bit?
Is it possible to find a mappack or damos for this old file?
Can someone guide me on how to do pops and bangs? my only clue is the ignition timing so far.
Any map packs out there?

SW:350042

Best regards

by **Lambda1** » Tue Sep 29, 2020 7:59 am

Its possible to do, i do before but...
1. you need slightly push throttle to generate a bit of air flow,
2. for best need decat,
3. not really power benefits are there.

by **Rust** » Tue Sep 29, 2020 3:46 pm

Lambda1 wrote:Its possible to do, i do before but...
1. you need slightly push throttle to generate a bit of air flow,
2. for best need decat,
3. not really power benefits are there.

The car has already been decat. And I am not aiming for a power increase. The car will be scrapped in a few months.

Best regards

by **Lambda1** » Tue Sep 29, 2020 3:49 pm

So you can think about and play arround... way better than get solution .

by **Rust** » Tue Sep 29, 2020 6:05 pm

Thanks for the reply
I will keep thinking then........

And I am not searching for a solution......id rather blow the engine up myself...... Than flashing a file that is made by someone I don't know.

Anyways I can not find any similar files from which I can make my own map pack from. I have never worked with these before......
And the only statements I can trace about making this old thing go popping and hard cutting is people who says it can be done without giving a clue in the right direction.

I will share my file and map pack here if I get things sorted.

Best regards everybody