Hello.

Please forgive me if this has already been covered. Ive done a fair bit of googlising, and haven't come up with much to get me started.

I know there are a bunch of high cost solutions out there, but im try to find a way of doing this much cheaper. Id be really surprised if a low cost or even freeware solution didnt exist.

I have a bunch of Bosch ECU's from various Seadoo Jetskis that are either in a state of unknown, or have older tunes of them that i want to either clone from another ECU, or write back to stock.

I do similar stuff with the use of TunerPro and PCMHammer with LS1 ecu's, and was hoping someone might be able to point me in the direction of a solution for these Bosch ECU's.

I'm not looking to be spoon fed, and im happy to learn my way, but im really struggling to find a thread to start pulling on.

Appreciate any guidance you genius folk may be able to provide would be very much appreciated.

Dave

pcm flash work read/write this ecu rotax. bosch me 17.8.5.

Bitbox with Tactrix 2.0 is a fairly cheap option.

bitbox write only virtual read.

and with bitbox read this ecu is neccesary open....

pcm flash , trasdata,ktag etc. work read on bench...without open ecu....