UNIVERSAL ADAPTER FOR WORKING WITH FRAME

Now you can make any adapter that is not on the market! You can make your own tool very easy. Pogopins can be soldered also
in different angles. All parts are same as on the picture.

Attention!
We offer 2 different dimensions of the adapter, L(large, 6cm wide) and S(small, 4cm wide) Please be sure that you are looking the right one. If you own non standard BDM frame with 4cm wide socket for adapter fitting, then you choose S, otherwise choose L.

No more tuning only over OBD, start real business and cover much more vehicles faster.
With BOOT MODE you can make full backup of the ECU in case that something goes wrong and you can than use that backup to clone your ECU to another one.

Technical specification
- supports stable and precise connection - with 2.5mm PCB there is no bending
- supports stable and reliable connection with precise golden pogopins
- very good impact resistance and nice handling with smooth PCB rounded edges
- very important cut out edges very close around the pinouts for great view while connecting to the ECU
- clear view of the ECU boot pad simplifies positioning of the adapter
- precise holes for golden pogopins which you can solder under the angle to get pogopins as close as possible
- every hole for pogopin has aditional pin where you can plug jumper cable and make circuit as you wish
- added 3x 470ohm, 3x 560ohm and 1000ohm resistors
- adapter width: 40mm
- adapter color: blue with white print

More details: http://www.ecubay.com/

Is it any good anybody tested ?

Good ingenious :D