Audi 3.0 TDI Drivers Wish

by **pmtuner1** » Wed Feb 13, 2013 12:41 am

Hello,

Anyone who knows what conversion formula to use in the 3.0 TDI Drivers Wish?

Thanks!!

by **Amon103** » Mon Mar 04, 2013 2:29 am

if this is not what you need

In order to see the X-axis (0.0122)

best regards

by **wiski** » Fri Mar 22, 2013 10:52 pm

What is 0.0122?
It is IQ in these not torque as in 2.0

by **RPM freak** » Sat Mar 23, 2013 11:48 am

3.0 TDI uses EDC16 ECU.

Drivers wish map is in NM. Factor is 0.1 to get the requested NM.
X axis is pedal position in %. Factor is 0.0122
Y is RPM factor 1

by **wiski** » Sat Mar 23, 2013 12:51 pm

Of course it's edc16.
I haven't see till now 3.0 tdi in which you need to apply that factor for pedal %
Z is in mg not in Nm in this ecu

by **RPM freak** » Sat Mar 23, 2013 2:22 pm

I have made a typing mistake. The correct factor for X is 0.01

EDC16 DW maps are always in NM

by **pmtuner1** » Tue Mar 26, 2013 12:12 am

Thanks all you for all answeres!
I was also learned that EDC16 uses Nm as Z factor in DW but in this case I doubt as the max number is "900".
I more think it is 90 mm3 fuel.

Anyone who KNOWS for SURE?

by **wiski** » Tue Mar 26, 2013 10:13 am

VW group doesn't use mm3. They use mg.

by **RPM freak** » Tue Mar 26, 2013 11:08 am

In your DW map you can ask for 1 000 000 Nm. Still the torque will be limited by Torque Limiter map.

by **pmtuner1** » Thu Mar 28, 2013 12:21 am

Request of mg fuel or mg air on the DW?

Of course the Nm will get limited after the DW but realistic would be to have top value quite near true value.
Othervise gas pedal would be "flat" in this case after 50% travel if linear.