Maps needed for tuning EDC15C2

by **Zibi** » Sat Oct 27, 2012 8:49 am

Hi

If there is two maps of IQ limit fuel temp do i have change both otr only first?

What for are two identical maps?

by **avacalho** » Fri Nov 23, 2012 12:47 am

ecuedit can you add some comments on each map on that .pdf?
I mean what is each map and what that influenciate and what must be done?
Thank you

by **ecuedit** » Fri Nov 23, 2012 12:57 am

Learning stays on you, if you get all served you will never learn...ask when you get stucked. ;)

by **ouissam2003** » Tue May 07, 2013 10:17 am

Thanks for this post, bacause i want to reprogramm my peugeot 406 2.2 hdi with winols 2.24

by **zok** » Sun May 12, 2013 11:46 am

ecuedit wrote:Learning stays on you, if you get all served you will never learn...ask when you get stucked. ;)

I got stuck with SVRPL.. how the hell can I find it? :cry: Max rail pressure is 1350, so most of SVRPLs should be 13500 (?), but one of them 14500 (FRP sensor measures up to 1500 bar).

Where should I look for it? Could it be near the rail pressure map? Is there any calculation involved, so that I don't look for a right value? :eh:

by **ecuedit** » Sun May 12, 2013 11:52 am

It the first 14500 value under injection duration 1 map...

by **zok** » Sun May 12, 2013 5:30 pm

It already took me few hours of thinking, but things are getting clearer. ;) I guess I'll be able to find all the values in my file quite soon. Those examples are a bit different from my file, but i'm getting closer and closer. 8-) Thanks!

by **zok** » Mon May 13, 2013 12:01 pm

Aigh.. :mrgreen:

I found a wish map, injection duration map, SOI map, EGR map, turbo boost map, something related to IAT, smoke map, turbo boost limiter map, overboost map, 3 SVRPL's and some other maps that I have to figure out - I'm still working on them.

I also found out that most of the maps in ECM Titanium are identified incorrectly ("injection at part throttle" etc), and many of them aren't even available to modify. The worst thing at ECM Titanium is that you can't find or modify any of single value limiters.

I never made it that far without manuals and your map list, @ecuedit. You'te the man! :thumbup:

by **highperf** » Fri May 17, 2013 5:06 am

You have forget 3 torque limiter, if You want i can give You later the adress for modif your pdf ;)
im on my phone now.

by **highperf** » Fri May 17, 2013 12:57 pm

Sans titre.JPG

[

on the file you have work, the start adrress are 68928, 68968, 689A8 you find it at 7XXXX TOO. on hdi edc15c2 2.0 and 2.2 they are 15X1 map the third torque limiter as always setup at 100MM3 but you have to work with the twoo fisrt torque limiter for a good job and understanding on edc15c2